Services

Speed Industry's services range from sales and basic part installation to full engine builds/swaps and professional dyno tuning on a Mustang AWD dynamometer. The 5800 square foot shop houses lifts that are able to accommodate vehicles with lowered ride heights. Speed Industry has wide-ranging fabrication capabilities including TIG welding equipment to design and create the part you need. We also maintain a climate controlled clean room for precision assembly of engine components and other work that requires extreme care.

As always, our sales and service team is always there to assist you in achieving your goals.

 

 

Dynamometer Rental

Dyno Hourly Rental (tuning allowed)
Setup fee:         $25
2WD:                 $120/hr
4WD:                 $150/hr
O2 fee:              $35

Dyno rental subject to approval. After first complete hour, time can be billed in half hour blocks.

Power Pull Packages (no tuning allowed)
Setup fee:         $25
2WD (3 runs):   $100
4WD (3 runs):   $130
O2 fee:              $35

 

Tuning

We currently tune the following:
- AEM
- Utec
- Hydra
- Any Subaru reflash
- Open source (Enginuity)
- Cobb ProTune
- Xede
- Hondata
- DSMlink

Full dyno tune includes logging with laboratory grade wideband and external map sensor and as many dyno pulls as it takes to get the tune done. We will learn your system if you don't see it listed.

Before making a dyno appointment, be sure to read the Dyno Checklist. We will not tune cars that have electrical or mechanical issues.

Car club & forum dyno days are available. Please call for group discounted rates. A minimum of 10 cars prepaid is required to run a dyno day.

Fees
Dyno Tuning fees start from $460. Set up fee per session is $25 per car. O2 fee per session is $35 per car.

Subaru ECU Flash
Fee for a flash (no dyno tuning) is $300. Our flashes are based on known working combinations that have been tested on the road and on the dyno. Contact us for further details

Cobb Subaru Protune
This is a fully customized map tuned on our Mustang dyno with a laboratory grade wideband using Cobb's ProTuner (now known as AccessTuner) software. Protune includes one pump gas map. Additional maps are $100 each, such as race gas maps.

Methanol Injection
We will tune methanol injection systems at our discretion. We reserve the right to refuse to tune any non-robust meth system (all systems should have a fail-safe). All methanol systems are not created equal. A vehicle will be tuned on pump gas fully at the normal tuning fee before any methanol will be used. The tuning fee for methanol will be an additional $200. We are NOT responsible for driveability, or any other issues relating to the design of your meth injection system.

Blow Through MAF
We have no problem tuning these, however there is a $100 charge due to the extra time it takes to scale it.

 

Labor Rates

For performance installations, diagnostics, and other work, our labor rate is $80 per hour if parts are purchased from Speed Industry. If parts are purchased elsewhere, the rate is $90 per hour. Engine building rates vary by engine and level of work required. In many instances external sources may be used for machining.

 

Fabrication Rates

Fabrication is unique, therefore cost is dependent on the materials chosen by the customer and the scope of the project. Fabrication needs to be planned and is not done on a walk-in basis. Minimum fabrication fee is $50.

 

Vehicles Left Overnight

Speed Industry is not responsible for any damage or theft from vehicles left at our facility for extended periods; this is why all vehicles serviced by Speed Industry are required to be insured. If your vehicle is not picked up when the project is complete, a fee of $30 per day will be added to the invoice for vehicle storage.